Machine Care and TroubleshootingAeroccino 4Select another machine
Digital user manualYou are in a tab selection : choose an option to display it's content below
Clean directly after every use
Remove the jug from the base.
Remove seal from lid.
Remove the whisk, and the spring from the whisk.
Hand washing: wash inner jug, seal, lid, whisk and spring with detergent and rinse with warm/hot water. Do not use abrasive material that might damage the surface of the equipment. Don’t immerse in water.
Dishwashing: put all parts except the base in the dishwasher at maximum 70°C/158°F.
Dry all Aeroccino parts with a fresh and clean towel, cloth or paper and reassemble all parts.
Clean before the first use and after each use according to the cleaning instructions. Place the whisk in the jug.
Fill milk frother up to one of the two «Max» level indicators: Lowest "Max foam" level indicator (120 ml) is for milk froth preparations. Highest "Max milk" level indicator (240 ml) is for hot milk preparations.
Put the lid on the Aeroccino. Make sure the connector is dry before you plug the Aeroccino to the base. The 4 buttons are steady on.
Choose your milk preparation by pressing the dedicated button to start. Button pressed blinks during preparation and become steady on when the preparation is ready.
Pour the milk preparation in the cup. Use only a non-metal spoon to collect the foam in the jug. For hot and cold milk froth, preparation takes approx. 80 sec. For hot milk, preparation takes approx. 150 sec. Preparation can be stopped at any time by pressing the button or removing the Aeroccino from the base.
Aeroccino turns off automatically after 9 minutes of non-use. Press any of the 4 buttons to switch ON the Aeroccino.
Aeroccino does not start.
Quality milk froth not up to standard or milk burnt.
Fast red lights blinking on the 4 buttons (Aeroccino error).
- a) The appliance is too hot: clean the jug under cool water. Be sure the whisk is attached correctly in the jug.
- b) Not enough milk: fill milk frother up to one of the two "max" level. All the 4 buttons blink rapidly (3 red and 1 blue) .
- c) Clean Aeroccino and check that there is no water on the base.
- d) If no change, then please call the Nespresso Club (800 852 3525 toll-free).
H=210mm // D=180mm
- Spare Parts
Do you require a replacement part for your machine?
Allow one of our Coffee Specialists to assist you through your Spare Part selection by calling the Nespresso Club at 1500498 (Monday to Friday, 9am – 6pm).